This is an excellent unit for the money. It is very sturdy with a solid frame and hose reel assembly that can be floor, wall, or ceiling mounted. I used 3/8"x 1-1/2" lag screws and washers to secure it to the bottom of a shelf (with 2x4's) just above my compressor. Leave about a two inch gap between the edge of the reel and the floor/wall/ceiling when you mount it to give the hose a little extra room.
From reading the instructions, I thought I would have to do a lot of setup and adjustments to get the unit working properly. Not So! Once I had the unit mounted and connected to the compressor it worked flawlessly from the get-go with no adjustments necessary. The spring return tension was set at the factory and worked perfectly the first time I tried it.
One thing that is a little tricky is the connection of the hose between the reel and your compressor. The unit ships with a 50' hose installed on the reel, but DOES NOT ship with the interconnect hose, so you will have to provide your own. I ordered the matching 3' Goodyear hose because my compressor was close to the reel. You may need a longer hose if it's farther away. The reason I say it is tricky has to do more with physics than the equipment itself. When you screw the hose into either the compressor end or the reel connector it's no problem, HOWEVER, now you have to screw the other end of the hose to the other device. As you start turning the hose in, it starts to twist it tighter and tighter into a knot until you have an unworkable mass of rubber hose. Not good. There are probably fittings available that allow the hose to be tightened without twisting, but there is another way. Simply pre-twist the hose 3 to 4 times counter to the direction you will be screwing it in. This way, as you tighten the hose fitting it is unwinding the twists you put in the hose beforehand. It may take a couple attempts but ultimately you should be able to get both ends of the hose attached without twists.
As for the reel, the main hose unrolls easily without binding or twisting, with the guide rollers keeping it properly aligned. The guide rollers allow you to pull the hose out at any angle up to 90 degrees on either side. It is a little tricky to get used to latching the hose while extending it. There are three "clicks" every half-revolution or so that you need to time so that you stop pulling right after the first or second click, otherwise, if you go too far past the third click it won't latch and you'll have to go another half-turn and try again. It's pretty easy after a little practice. To release the hose and let the unit wind it back in, simply give it a little downward tug and let it start pulling it in. It's a good idea not to let the hose go flying back in at high speed, rather, slow it down a bit with your hand as it retracts.
I haven't had the unit installed very long, but I did drag out all 50' of hose tonight to blast out every smoke detector in the house. This was easily accomplished with the reel holding the hose fully extended while I did my work. Afterwards, with just a little tug and some guidance, the hose easily rewound itself neatly back on the reel. NICE!
If things change I'll update this review, but right now I'm quite happy with my purchase.
Add to your order
-
Coverage for accidental damage including drops, spills, and broken parts, as well as breakdowns (plans vary) -
24/7 support when you need it. -
Quick, easy, and frustration-free claims.
Cover this product:
2-Year Protection Plan $9.99
3-Year Protection Plan $13.49
Cover all of your eligible devices:
Asurion Complete Protect: One plan covers all eligible past and future purchases (Renews Monthly Until Cancelled) $16.99/month
Select a plan
Add to your order
- Coverage for accidental damage including drops, spills, and broken parts, as well as breakdowns (plans vary)
- 24/7 support when you need it.
- Quick, easy, and frustration-free claims.
Cover this product:
Select a plan
Add Prime
to get Fast, Free delivery
$91.99 with 46 percent savings
Typical price: $169.99 
The Typical Price is determined using the 90-day median price paid by customers for the product in the Amazon store. We exclude prices paid by customers for the product during limited time promotions and prices paid in the Amazon Haul store
Learn more
Learn more
There is a newer version of this item:
Frequently bought together
This item: Goodyear Air Hose Reel Retractable 3/8" Inch x 50' Foot SBR Rubber Hose Max 300PSI Heavy Duty Industrial Steel Single Arm Construction
$91.99
Get it as soon as Friday, Apr 11
Only 4 left in stock - order soon.
+
$14.05 ($2.34/Foot)
Get it as soon as Thursday, Apr 10
In Stock
+
$169.99
Get it Apr 15 - 17
Only 15 left in stock - order soon.
Total price: $00
To see our price, add these items to your cart.
Choose items to buy together.
Related Climate Pledge Friendly items
Page 1 of 1 Start overPage 1 of 1
Sustainability features
This product has sustainability features recognized by trusted certifications.Reduced air and/or water in the product or packaging for more efficient transportation.As certified by
Compact by Design (Amazon-developed Certification)
Compact by Design identifies products that, while they may not always look very different, have a more efficient design. By reducing water and/or air in the product or packaging, these become more efficient to ship. At scale, these small differences in product size and weight lead to significant carbon emission reductions.Sustainability features
This product has sustainability features recognized by trusted certifications.Contains at least 50% recycled material.As certified by
GreenCircle Certified: Recycled Content
GreenCircle certifies claims that a product is made of pre- or post-consumer material when it is manufactured. GreenCircle verifies the sources of recycled materials and analyzes the recycled content used in the product to determine the percentage of pre-consumer or post-consumer content based on international standards and definitions for recycled content. A product must contain 50% recycled content to qualify for Climate Pledge Friendly. This does not include packaging.Sustainability features
This product has sustainability features recognized by trusted certifications.Reduced air and/or water in the product or packaging for more efficient transportation.As certified byCompact by Design (Amazon-developed Certification)
Compact by Design identifies products that, while they may not always look very different, have a more efficient design. By reducing water and/or air in the product or packaging, these become more efficient to ship. At scale, these small differences in product size and weight lead to significant carbon emission reductions.Sustainability features
This product has sustainability features recognized by trusted certifications.Made with materials from well-managed forests, recycled materials, and/or other controlled wood sources.As certified by
The Forest Stewardship Council
The Forest Stewardship Council (FSC) supports responsible forestry, which is a vital solution to combat climate change. Choosing FSC-certified products – whether furniture, building materials, paper, rubber, or textiles – helps protect forests, wildlife, clean water and supports the Indigenous Peoples, forest workers and communities who depend on them. Choosing FSC-certified products can also help to mitigate climate change by supporting responsible management of the world’s forests. For a better future, choose FSC.Sustainability features
This product has sustainability features recognized by trusted certifications.Made with chemicals safer for human health and the environment.As certified by
U.S. EPA Safer Choice
U.S. Environmental Protection Agency (EPA) created the Safer Choice label to help you find products made with safer ingredients for the health of families, pets, workplaces, and the environment. Safer Choice certified products have been carefully evaluated by EPA scientists. Every ingredient must meet strict safety criteria for both human health and the environment. Products must also meet performance requirements to make sure they work. Products made with safer ingredients can help improve indoor air quality and protect municipal waterways.Sustainability features
This product has sustainability features recognized by trusted certifications.Made with materials from well-managed forests, recycled materials, and/or other controlled wood sources.As certified byThe Forest Stewardship Council
The Forest Stewardship Council (FSC) supports responsible forestry, which is a vital solution to combat climate change. Choosing FSC-certified products – whether furniture, building materials, paper, rubber, or textiles – helps protect forests, wildlife, clean water and supports the Indigenous Peoples, forest workers and communities who depend on them. Choosing FSC-certified products can also help to mitigate climate change by supporting responsible management of the world’s forests. For a better future, choose FSC.
Top reviews from the United States
There was a problem filtering reviews. Please reload the page.
- Reviewed in the United States on June 10, 2017
This is an excellent unit for the money. It is very sturdy with a solid frame and hose reel assembly that can be floor, wall, or ceiling mounted. I used 3/8"x 1-1/2" lag screws and washers to secure it to the bottom of a shelf (with 2x4's) just above my compressor. Leave about a two inch gap between the edge of the reel and the floor/wall/ceiling when you mount it to give the hose a little extra room.This is an excellent unit for the money
Reviewed in the United States on June 10, 2017
From reading the instructions, I thought I would have to do a lot of setup and adjustments to get the unit working properly. Not So! Once I had the unit mounted and connected to the compressor it worked flawlessly from the get-go with no adjustments necessary. The spring return tension was set at the factory and worked perfectly the first time I tried it.
One thing that is a little tricky is the connection of the hose between the reel and your compressor. The unit ships with a 50' hose installed on the reel, but DOES NOT ship with the interconnect hose, so you will have to provide your own. I ordered the matching 3' Goodyear hose because my compressor was close to the reel. You may need a longer hose if it's farther away. The reason I say it is tricky has to do more with physics than the equipment itself. When you screw the hose into either the compressor end or the reel connector it's no problem, HOWEVER, now you have to screw the other end of the hose to the other device. As you start turning the hose in, it starts to twist it tighter and tighter into a knot until you have an unworkable mass of rubber hose. Not good. There are probably fittings available that allow the hose to be tightened without twisting, but there is another way. Simply pre-twist the hose 3 to 4 times counter to the direction you will be screwing it in. This way, as you tighten the hose fitting it is unwinding the twists you put in the hose beforehand. It may take a couple attempts but ultimately you should be able to get both ends of the hose attached without twists.
As for the reel, the main hose unrolls easily without binding or twisting, with the guide rollers keeping it properly aligned. The guide rollers allow you to pull the hose out at any angle up to 90 degrees on either side. It is a little tricky to get used to latching the hose while extending it. There are three "clicks" every half-revolution or so that you need to time so that you stop pulling right after the first or second click, otherwise, if you go too far past the third click it won't latch and you'll have to go another half-turn and try again. It's pretty easy after a little practice. To release the hose and let the unit wind it back in, simply give it a little downward tug and let it start pulling it in. It's a good idea not to let the hose go flying back in at high speed, rather, slow it down a bit with your hand as it retracts.
I haven't had the unit installed very long, but I did drag out all 50' of hose tonight to blast out every smoke detector in the house. This was easily accomplished with the reel holding the hose fully extended while I did my work. Afterwards, with just a little tug and some guidance, the hose easily rewound itself neatly back on the reel. NICE!
If things change I'll update this review, but right now I'm quite happy with my purchase.
Images in this review
- Reviewed in the United States on January 18, 2025
I bought both the air hose and electrical cord reel. The provided mounting hardware isn’t as good as these reels are. I was terrible about leaving cords and air lines laying around before these. They are both heavy duty reels and work perfect. They are expensive,but they are nice. Highly recommend getting both.
Goodyear knocks it out the park.
Reviewed in the United States on January 18, 2025
Images in this review
- Reviewed in the United States on March 29, 2025
- Reviewed in the United States on March 30, 2025
Very impressed with the quality of this reel.
Images in this review
- Reviewed in the United States on July 10, 2023
This seems like a decent reel and works well. The hose it came with is total garbage and wouldn’t make it thru a summer in my Arizona garage, so I purchased a 3/8” Goodyear hose and put on it made in America. Good American made reels would be Reelcraft or CoxReels but I don’t use one enough to justify the price.
This mounted right in place where I had a Northern Tools Klutch Reel mounted. I didn’t even have to drill as it was a perfect fit.
Images in this review
- Reviewed in the United States on April 2, 2025
- Reviewed in the United States on July 12, 2024
Top reviews from other countries
-
-
- robert mc nultyReviewed in the United Kingdom on November 6, 2019
well worth buying for workshop.
-
