Ok, there is a lot to unpack when it comes to some of the negative things that others have had to say in regards to these tiles. The one thing that most people do not seem to understand is that tiles like this ARE NOT SOUND BLOCKING! They are meant only to absorb echoes in an environment.
In my case, these were installed with the idea of toning down the room a bit. I run a couple of industrial lasers that require supporting equipment like a water chiller, air compressor and more than one fume extraction fans. All combined add up quickly decibel wise and the tiles do an excellent job of quieting the environment just by removing the echoes so I only hear the original source of the noise and not it bouncing off everything else and hitting my ears milliseconds later.
These tiles are not a “Silver Bullet”, but they are darn close. I have tried other sound dampening tiles and found them to be inferior in performance and a pain in the *ss to install with the sub-par adhesive squares that come with them, and just plain look like crap (I have a whole contractor’s garbage bag full of them now because they are that bad).
The foam on these was a bit odoriferous at first, but dissipated quickly. Expansion of the tiles after removing them from the vacuum packs was almost instantaneous and were usable within 3-5 minutes and the density is far superior to other tiles I have tried.
For installing these, I DID NOT use adhesive or tape. Since they were going over drywall the most secure way that I found to mount them was using a pair of Lineman’s pliers to push in 1” long round top blued nails (5 per tile). They are invisible once seated unless you look for them and they do not compress the foam and distort, thus degrade the function of, the tiles like staples from a staple gun will. Using the nails also made it exceedingly easy to remove the tiles for repositioning when needed due to installer error ;-)
For my first installation, I covered the ceiling of the area where my machinery that makes the most noise resides. The floor was then covered with ¾” thick rubber stall mats which are also great for deadening noise reflections (echoes). Some have commented that my current 12’ X 11’ area is creepy in the fact that once they enter it, the normal echoes that we are all used to hearing almost disappear (this can cause discomfort/disorientation for some since they are something the brain uses for spatial cues).
Would I buy these again, absolutely! Actually I already did, I’m just waiting for them to arrive so I can start installing them in the rest of the Shop ;-)
Yes, I did get some dud tiles (mashed due to the manufacturing process, packing, whatever) as others mentioned, I just set these aside and used them when partial tiles were called for. In the end, it worked out just fine and the loss due to defective tiles was minimal at best (no tiles were a total loss).
Just the tiles on the ceiling alone made an immediate difference, when coupled with the flooring the effect was far beyond my expectations! I cannot wait to tile the other two thirds of the ceilings when the rest of the tiles I ordered arrive.
Frequently bought together
This item: 36 Pack AUSLET Acoustic Panels 12 x 12 x 2 Inches, Pyramid Sound Proof Foam Panels for Wall, High Density Black Acoustic Foam Panels,Soundproof Wall Panels
$44.99
Get it as soon as Friday, Apr 11
In Stock
+
$19.99 ($0.07/Count)
Get it as soon as Friday, Apr 11
In Stock
+
$26.95
Get it as soon as Friday, Apr 11
In Stock
Total price: $00
To see our price, add these items to your cart.
Choose items to buy together.
Top rated similar items
Page 1 of 1 Start overPage 1 of 1
Product Description
36 Pack Pyramid Acoustic Panels
Aluset acoustic panels have been a perfect solution for you as part of an overall approach to manage and mitigate unwanted audio issues. Adding these will help a lot with stabilizing the sound, and deadening some of the sound going out of the room.
The groove shape of Pyramid panels increases the contact area with sound which makes a significant difference in controlling unwanted echoes, reverb in acoustic studio.
From the brand
Experts in Room Acoustics
Focus on Acoustic Treatment over 10 Years
-
Since 2010, AUSLET has been committed to perfecting room acoustics with high-performance sound solutions. Our expertise in acoustic treatment ensures a superior audio experience, whether for music production, broadcasting, or professional spaces.
Rooted in craftsmanship and continuous innovation, AUSLET upholds a legacy of excellence. Our commitment to sound quality remains unwavering, shaping spaces where acoustics truly matter.
-
AUSLET Sound Proof Foam Panels
-
AUSLET Sound Proof Foam Panels
-
"Build Your Own Space"
Drown out distractions with our panels that turn noise into tranquility. Tough, stylish, and tailored to fit your space.
-
"Tune Up Your Sound"
Elevate your music room with our sound-absorbing foam. Enjoy crisp, clear notes without echoes, creating a perfect practice haven.
-
"Acoustic Mastery for Studios"
Upgrade your recording studio with our premium acoustic foam, designed to dampen echoes and enhance clarity in sound.
-
"Game On: Silence the Noise"
Energize your gaming room with our acoustic foam. Mute the outside world and boost your gaming immersion.
Compare with similar items
This Item  36 Pack AUSLET Acoustic Panels 12 x 12 x 2 Inches, Pyramid Sound Proof Foam Panels for Wall, High Density Black Acoustic Foam Panels,Soundproof Wall Panels | Recommendations  |  |  |  |  | |
| Price | $44.99 | $44.99 | $57.99 | $43.99 | $58.99 | $49.98 |
| Delivery | Get it as soon as Friday, Apr 11 | Get it as soon as Friday, Apr 11 | Get it as soon as Friday, Apr 11 | Get it as soon as Friday, Apr 11 | Get it as soon as Friday, Apr 11 | Get it as soon as Friday, Apr 11 |
| Customer Ratings | ||||||
| Sold By | Auslet | GUERRI | Auslet | Enkiyun | Yisiweyy | Focusound |
Excellent Form, Function and Appearance for the Cost
Ok, there is a lot to unpack when it comes to some of the negative things that others have had to say in regards to these tiles. The one thing that most people do not seem to understand is that tiles like this ARE NOT SOUND BLOCKING! They are meant only to absorb echoes in an environment.In my case, these were installed with the idea of toning down the room a bit. I run a couple of industrial lasers that require supporting equipment like a water chiller, air compressor and more than one fume extraction fans. All combined add up quickly decibel wise and the tiles do an excellent job of quieting the environment just by removing the echoes so I only hear the original source of the noise and not it bouncing off everything else and hitting my ears milliseconds later.These tiles are not a “Silver Bullet”, but they are darn close. I have tried other sound dampening tiles and found them to be inferior in performance and a pain in the *ss to install with the sub-par adhesive squares that come with them, and just plain look like crap (I have a whole contractor’s garbage bag full of them now because they are that bad).The foam on these was a bit odoriferous at first, but dissipated quickly. Expansion of the tiles after removing them from the vacuum packs was almost instantaneous and were usable within 3-5 minutes and the density is far superior to other tiles I have tried.For installing these, I DID NOT use adhesive or tape. Since they were going over drywall the most secure way that I found to mount them was using a pair of Lineman’s pliers to push in 1” long round top blued nails (5 per tile). They are invisible once seated unless you look for them and they do not compress the foam and distort, thus degrade the function of, the tiles like staples from a staple gun will. Using the nails also made it exceedingly easy to remove the tiles for repositioning when needed due to installer error ;-)For my first installation, I covered the ceiling of the area where my machinery that makes the most noise resides. The floor was then covered with ¾” thick rubber stall mats which are also great for deadening noise reflections (echoes). Some have commented that my current 12’ X 11’ area is creepy in the fact that once they enter it, the normal echoes that we are all used to hearing almost disappear (this can cause discomfort/disorientation for some since they are something the brain uses for spatial cues).Would I buy these again, absolutely! Actually I already did, I’m just waiting for them to arrive so I can start installing them in the rest of the Shop ;-)Yes, I did get some dud tiles (mashed due to the manufacturing process, packing, whatever) as others mentioned, I just set these aside and used them when partial tiles were called for. In the end, it worked out just fine and the loss due to defective tiles was minimal at best (no tiles were a total loss).Just the tiles on the ceiling alone made an immediate difference, when coupled with the flooring the effect was far beyond my expectations! I cannot wait to tile the other two thirds of the ceilings when the rest of the tiles I ordered arrive.
Top reviews from the United States
There was a problem filtering reviews. Please reload the page.
- Reviewed in the United States on March 14, 2024Size: 12 x 12 x 2 InchesColor: 36 Pack-30kg/m3Verified Purchase
Ok, there is a lot to unpack when it comes to some of the negative things that others have had to say in regards to these tiles. The one thing that most people do not seem to understand is that tiles like this ARE NOT SOUND BLOCKING! They are meant only to absorb echoes in an environment.
Excellent Form, Function and Appearance for the Cost
Reviewed in the United States on March 14, 2024
In my case, these were installed with the idea of toning down the room a bit. I run a couple of industrial lasers that require supporting equipment like a water chiller, air compressor and more than one fume extraction fans. All combined add up quickly decibel wise and the tiles do an excellent job of quieting the environment just by removing the echoes so I only hear the original source of the noise and not it bouncing off everything else and hitting my ears milliseconds later.
These tiles are not a “Silver Bullet”, but they are darn close. I have tried other sound dampening tiles and found them to be inferior in performance and a pain in the *ss to install with the sub-par adhesive squares that come with them, and just plain look like crap (I have a whole contractor’s garbage bag full of them now because they are that bad).
The foam on these was a bit odoriferous at first, but dissipated quickly. Expansion of the tiles after removing them from the vacuum packs was almost instantaneous and were usable within 3-5 minutes and the density is far superior to other tiles I have tried.
For installing these, I DID NOT use adhesive or tape. Since they were going over drywall the most secure way that I found to mount them was using a pair of Lineman’s pliers to push in 1” long round top blued nails (5 per tile). They are invisible once seated unless you look for them and they do not compress the foam and distort, thus degrade the function of, the tiles like staples from a staple gun will. Using the nails also made it exceedingly easy to remove the tiles for repositioning when needed due to installer error ;-)
For my first installation, I covered the ceiling of the area where my machinery that makes the most noise resides. The floor was then covered with ¾” thick rubber stall mats which are also great for deadening noise reflections (echoes). Some have commented that my current 12’ X 11’ area is creepy in the fact that once they enter it, the normal echoes that we are all used to hearing almost disappear (this can cause discomfort/disorientation for some since they are something the brain uses for spatial cues).
Would I buy these again, absolutely! Actually I already did, I’m just waiting for them to arrive so I can start installing them in the rest of the Shop ;-)
Yes, I did get some dud tiles (mashed due to the manufacturing process, packing, whatever) as others mentioned, I just set these aside and used them when partial tiles were called for. In the end, it worked out just fine and the loss due to defective tiles was minimal at best (no tiles were a total loss).
Just the tiles on the ceiling alone made an immediate difference, when coupled with the flooring the effect was far beyond my expectations! I cannot wait to tile the other two thirds of the ceilings when the rest of the tiles I ordered arrive.
Images in this review
- Reviewed in the United States on February 8, 2025Size: 12 x 12 x 2 InchesColor: 36 Pack-30kg/m3Verified Purchase
- Reviewed in the United States on February 22, 2025Size: 12 x 12 x 2 InchesColor: 36 Pack-30kg/m3Verified Purchase
- Reviewed in the United States on February 10, 2023Size: 12 x 12 x 2 InchesColor: 36 Pack-30kg/m3Verified Purchase
- Reviewed in the United States on December 23, 2024Size: 12 x 12 x 2 InchesColor: 36 Pack-30kg/m3Verified Purchase
- Reviewed in the United States on June 5, 2024Size: 12 x 12 x 2 InchesColor: 36 Pack-30kg/m3Verified Purchase
Top reviews from other countries
- Mohamed GalalReviewed in the United Arab Emirates on February 6, 2025
Not much recommend
Size: 12 x 12 x 2 InchesColor: 36 Pack-30kg/m3Verified Purchase - Amazon CustomerReviewed in the United Arab Emirates on March 16, 2025
It should be with a sticker
Size: 12 x 12 x 2 InchesColor: 36 Pack-30kg/m3Verified Purchase - KankiReviewed in the United Kingdom on March 19, 2025
Good quality, excellent form
- Patrick FalconerReviewed in the United Kingdom on February 12, 2025
Good stuff
